12.1 Factory Default Configuration

12.1 Factory Default Configuration

P Code	Parameter Description	Default		P Code	Parameter Description	Default
P1	Input type	Ca.TC		P35	Sensor break alarm type	on
P2	Decimal point position	nnnn		P36	Sensor break safe output power	0.0
P3	Low scale range	-328		P37	Sensor break alarms output	none
P4	High scale range	2502		P41	Timer type	none
P5	Linear input low mV	0.0		P42	Timer resolution	Hour
P6	Linear input high mV	80.0		P43	Timer end type	off
P7	Control type	HP
P8	Cooling algorithm	Lin		P51	Logic 1 input function	none
P11	Output 1	Heat		P52	Logic 2 input function	none
P12	Output 2	none		P61	Digital Comms address	1
P13	Output 3	none		P62	Digital Comms baud rate	9600
P14	Output 4	AL2		P63	Digital Comms parity	none
P15	DC output range	4-20mA		P64	Digital Comms master/slave	none
P16	Retransmission scale low value	0.0		P65	Digital Comms Retrans Address	0
P17	Retransmission scale high value	400.0		P71	F1 pushbutton functionality	A-M
P21	Alarm 1 type	none		P72	F2 pushbutton functionality	t.St
P22	Alarm 1 latching	none		P73	Page pushbutton functionality	AC.AL
P23	Alarm 1 blocking	no		P74	Content of second line display	STD
P24	Alarm 2 type	Hi		P75	Content of third line display	oP
P25	Alarm 2 latching	none		P76	Level 2 passcode	2
P26	Alarm 2 blocking	no		P77	Configuration level passcode	4
P27	Alarm 3 type	none
P28	Alarm 3 latching	none		P81	Energy meter source	none
P29	Alarm 3 blocking	no		P82	Energy meter nominal load power	0.10
P31	Current transformer source	none		P82	Energy meter nominal load power
P32	Current transformer range	100.0		rEc.S	Recovery point save	none
P33	Current transformer alarm latching	none		rEc.L	Recovery point load	none
P34	Loop break alarm time	off		PHAS	Calibration phase	none